Maintain your equipment to prevent future problems and unwanted costs. Keep your cooling and heating system at peak performance by having a contractor do annual pre-season check-ups. Contractors get busy once summer and winter come, so it’s best to check the cooling system in the spring and the heating system in the fall. Remember, you might plan the check-ups around the time changes in the spring and fall.
Common A typical maintenance check-up should include the following;
- Check thermostat settings
- Tighten all electrical connections
and measure voltage and current on motors. Faulty electrical connections can cause unsafe operation of your system and reduce the life of major components.
- Lubricate all moving parts.
Parts that lack lubrication cause friction in motors and increase the amount of electricity you use.
- Check and inspect the condensate drain
in your central air conditioner, furnace, and/or heat pump (when in cooling mode). A plugged drain can cause water damage in the house and affect indoor humidity levels.
- Check controls of the system
to ensure proper and safe operation. Check the starting cycle of the equipment to assure the system starts, operates, and shuts off properly.
to ensure the cooling and heating system keeps you comfortable when you are home and saves energy while you are away.
Clean evaporator and condenser air conditioning coils
- Check your central air conditioner’s refrigerant level
and adjust if necessary. Too much or too little refrigerant will make your system less efficient increasing energy costs and reducing the life of the equipment.
- Clean and adjust blower components to provide proper system airflow for greater comfort levels
Airflow problems can reduce your system’s efficiency by up to 15 percent.
- Check all gas (or oil) connections, gas pressure, burner combustion, and heat exchanger
- Inspect, clean, or change air filters
Dirty coils reduce the system’s ability to cool your home and cause the system to run longer, increasing energy costs and reducing the life of the equipment.
Improperly operating gas (or oil) connections are a fire hazard and can contribute to health problems. A dirty burner or cracked heat exchanger causes improper burner operation. Either can cause the equipment to operate less safely and efficiently.
Actions to Do Yourself
once a month in your central air conditioner, furnace, and/or heat pump. Your contractor can show you how to do this. A dirty filter can increase energy costs and damage your equipment, leading to early failure.